.300 Blackout Ballistics Chart

.300 Blackout drop charts for a supersonic 110 grain load and a subsonic 208 grain load. These are two different jobs on two different setups, and the subsonic table is also shown with a 50 yard zero. Every number below is solved live by the ballistic calculator on this site, not copied from a book — treat it as a reference starting point, not a substitute for truing your own rifle at distance.

Standard conditions used for every chart on this page

Zero
100 yd
Sight height
1.5 in over bore
Atmosphere
59 °F, 29.92 inHg, 50% RH, 0 ft (ICAO standard)
Wind
10 mph at 90° (90° = full-value crosswind from the right)
Shooting angle
Spin drift / Coriolis
Off — not modelled by this solver

.300 Blackout factory loads

Muzzle velocity
2375 fps
Bullet
110 gr Hornady
BC
0.29 G1
Drop @ 500 yd
-103.7 in / -19.81 MOA / -5.76 MIL
Drop @ 1000 yd
Not solved past 600 yd
10 mph wind @ 500 yd
47.4 in / 2.63 MIL
Goes subsonic
about 600 yd

Source: Hornady BLACK .300 Blackout 110 gr V-MAX (published G1 BC 0.290, 2375 fps). Manufacturer page. Drag model labelled on every table: G1.

Open this load in the calculator
.300 Blackout 110 gr drop chart — inches over range, 100 yd zero
.300 Blackout 110 gr velocity and energy chart — fps and ft·lbf over range

.300 Blackout 110 gr drop and wind table (G1)

.300 Blackout 110 gr V-MAX (supersonic) trajectory: drop, wind drift, velocity, energy and time of flight
Range (yd)Drop (in)Drop MILWind MILVelocity (fps)
0-1.50.000.002375
500.10.070.232229
1000.00.000.422090
150-2.1-0.390.641955
200-6.5-0.910.881826
250-13.5-1.501.131703
300-23.6-2.181.401586
350-37.0-2.941.691477
400-54.4-3.781.991377
450-76.4-4.722.301286
500-103.7-5.762.631206
550-137.1-6.922.981138
600-177.0-8.193.311082

Dimmed rows are below the speed of sound, where published coefficients and this point-mass model are both least reliable. The solver stops once velocity falls too low to model honestly.

.300 Blackout mini DOPE card

Range (yd)Elevation MILElevation MOAWind MILWind MOA
100-0.00-0.000.421.46
2000.913.110.883.01
3002.187.501.404.82
4003.7813.001.996.84
5005.7619.812.639.06
6008.1928.173.3111.39
Build a full DOPE card

How to use this chart

  • Match the zero first. These tables assume a 100 yard zero; a 200 yard zero shifts every row.
  • Match the sight height. 1.5 inches is used here; a high AR mount is closer to 2.6 inches.
  • Match the air. Standard sea-level air is thicker than most hunting country, so real drop at altitude is usually less than shown.
  • True your muzzle velocity. Box velocity comes from a test barrel — chronograph yours, then re-run it in the calculator.

Related cartridges

.300 Blackout ballistics FAQ

How much does .300 Blackout drop at 500 yards?
.300 Blackout with the Hornady 110 gr V-MAX (supersonic) load (0.29 G1 BC at 2375 fps) drops 103.7 inches below the line of sight at 500 yards from a 100 yard zero in standard sea-level air, which is 19.81 MOA or 5.76 mils of elevation. It is still carrying 1206 fps and 355 ft·lbf there.
How much does .300 Blackout drop at 1000 yards?
The table here stops at 600 yards for this load, because the solver will not report a trajectory once velocity falls below the range where this model is trustworthy. Use the shorter distances and confirm the rest with live fire.
How much does a 10 mph crosswind push .300 Blackout?
A full-value 10 mph wind moves it 15.1 inches at 300 yards and 47.4 inches at 500 yards — 2.63 mils. Half-value wind is roughly half that; the wind hold, not the drop, is what usually misses.
Should I dial MIL or MOA for this chart?
Whichever your scope is marked in — the two columns describe the same come-up. One mil is 3.6 inches at 100 yards and one MOA is about 1.047 inches, so mils give coarser, faster clicks and MOA gives finer ones. Never mix a mil reticle with an MOA turret.
Where does .300 Blackout go subsonic with this load?
Around 600 yards under these conditions. Rows past that are dimmed on the table because drag behaviour through the transonic band is the least predictable part of the flight.

Before you trust these numbers

Factory muzzle velocity is a starting point measured in a test barrel. Barrel length, throat, temperature and lot number all move it, and 50 fps of error is worth most of a click at distance. Confirm on paper at 300 and beyond before you hold off an animal or a plate.

Want to keep a rifle, its chronograph data and your trued drops in one place? Trajek saves rifles and lets you true them. Sign up for updates when new cartridge charts go live.